Comments on: How to troubleshoot your Everwarm Fireplace Remote. (SKY-4001TH)

By: Tony Kocheff

Tony Kocheff — Thu, 13 Nov 2025 18:06:52 +0000

You need to change the batteries in both your receiver box AND remote. Then you have to have the receiver box set in the middle to Remote in order for the remote to operate the fireplace. But changing the batteries should fix your issue.

By: Tony Kocheff

Tony Kocheff — Thu, 13 Nov 2025 18:04:18 +0000

Hmmm, that’s interesting. It sounds like you know how everything works. I would try to just re-learn it to see if it resets it and starts working correctly.

By: Popscott

Popscott — Thu, 23 Oct 2025 23:13:12 +0000

installed 2024… Model ew 4001th-a remote…
Had everything working OK last year. Located remote in a “sweet” spot where temp would work nicely…
Did my yearly battery change in remote and receiver..
Now it all still turns on and off as should, but having a bear of a time to get to regulate… had the remote temp set to “turn on” at 64F but the room temperature gets way to cold and then goes way to hot…. the room temp on remote went to 71F once and never shut the logs off? The room temp on the remote not consistent with other known room temp readings…it seems to drop below the 64F to 62F and heat to maybe a “too warm” 69-70F before shutting off… I am well acquainted with the remote setting and display, it seems the differential setting are not maintaining a comfortable temp…. same scenario as last year, same remote location, room ceiling fans, flame height on logs,etc.

do I have to “re-learn” the remote and receiver if batteries replaced on both?

Thanks…

By: M cash

M cash — Tue, 21 Oct 2025 15:19:17 +0000

Remote shows display
Box has flashing red light when set to remote
Box will turn logs on when set to ON

Remote on and off buttons do nothing

By: Tony Kocheff

Tony Kocheff — Tue, 28 Jan 2025 15:04:20 +0000

Does your remote show anything on the screen?

By: Tony Kocheff

Tony Kocheff — Tue, 22 Oct 2024 16:42:35 +0000

The “Set” button allows you to control the thermostat for your gas logs. If you want the logs to automatically turn on or off when the room reaches a certain temperature, this button allows that. Since your remote acts as the thermostat, the temperature reading will be based on where the remote is located in the room.

To activate thermostat mode, simply hold down the “Set” button until the display shows your desired room temperature, then release it. The fireplace will turn on and heat the room until the temperature around the remote matches your setting, at which point it will automatically shut off.

By: Erik Upton

Erik Upton — Tue, 22 Oct 2024 00:46:33 +0000

What is the set button used for?

By: Tony Kocheff

Tony Kocheff — Wed, 07 Feb 2024 20:20:18 +0000

It is just letting you know that the batteries are dying and need to be replaced.

By: Victoria Blossom

Victoria Blossom — Mon, 05 Feb 2024 01:48:25 +0000

I have my gas logs and remote for about 2 years and it has worked great!! My receiver box just started blinking 3 times. Everything still works so why is it blinking?
Thanks

By: Tony Kocheff

Tony Kocheff — Tue, 30 Jan 2024 19:56:17 +0000

Hi Kathy, if you have done all of the steps in the article and it is still not working, you may be needing a new remote. They can be purchased here – https://www.ebay.com/itm/233892643310